How to Use Ceramic Motor Seal?

Leaks on the head gasket of a vehicle are inevitable and when it happens, it can result to engine overheat which can be an expensive repair. The good thing is that there is a ceramic motor seal that could be used as an easy and quick solution. It doesn’t matter what the model, make or year of your car because leaks in the cylinder head gasket of your internal combustion engine can cause chain of problems. Whether it is because of engine overheat or due to high mileage and tear and wear, the cylinder head gaskets may result to leak and other issues.

When the cylinder head gasket starts to leak, this indicates that there’s a leak in the engine coolant, either to the crankcase of the engine or into several cylinders of the engine. If you wish to learn more, then it will be wise to pay a visit to this site.

There are minor and major issues for the head gasket leaks that you must address. For minor problems, the car is still driveable but it is going to suffer from diminished engine performance, overheating and slow coolant consumption. But when you have a serious issue with the leaks, then the engine has higher probability of suffering from major engine performance problems and overheating, blow white smoke out the tail pipes and excess coolant contamination. In more serious problems, you are going to need total engine replacement as the head gasket leak makes the car in an undriveable state. It’s okay not to immediately deal with the leak on your head gasket, but be ready with the consequences, you can view here.

Irontite functions by sealing the head gasket leaks on the engine from within using cooling passages of the car and transporting it to where the leak is located. To know the real problem of your car, it is best to contact a technician first and have them check your engine before you push through with the solution.

Here are some of the things that you ought to do say that it is the cause of the problem.

#1. Make sure to check the back of Thoro-Flush to be able to see how it should be used correctly.

#2. Find and open your car’s radiator cap and then, put the engine block sealer to the engine.

#3. Once you’re done pouring the right amount of the engine block sealer to engine coolant, make sure it’s at the proper level and get a new cap.

#4. Start your engine and turn on your heater to maximum flow and heat.

#5. Keep the engine in idle for 15 minutes at least or for how long it is instructed on the engine block sealer.

This will salvage your car’s engine so do it now!